...The latest Xflat200 unit from the Xflat range offers the highest possible comfort in its category. Thanks to a well-thought-out design, advanced technologies and system „MultiFlex“ provides users with maximum comfort and efficiency in everyday life. Simplicity and flexibility of assembly are key factor for users and installation companies.
Option of remote control by WIFI and connection to smart home system
The option to connect an external pre-heater and after-heater controlled directly by unit. Thanks to this solution, heaters are operating only when needed.
The unit stands out by low weight and small height (only 16kg and 210mm). The option to install the unit under the ceiling or vertically on the wall.
"MultiFlex" system allowing maximum flexibility of the unit
Low weight 16 kg
Small installation height 210mm
Installation under the ceiling and vertically on the wall
Central unit Xflat200 with heat and humidity recovery. This is very suitable device for the ventilation of apartments and family houses, with its air output of 200 m3/h (alternatively 150 m3/h). The unit can be installed both ways - under the ceiling or vertically on the wall, due to its smart design. Xflat200 can be mounted on ceilings of normal height without getting in the way, thanks to its minimum height. The biggest advantage is the universality and flexibility of the connection.
The Xflat200 recuperation unit provides maximum versatility both in selection and even during installation, when changes are often already difficult. Thanks to the MULTIFLEX system, you can choose correct air output of 150 or 200 m3/h directly on the unit. The unit can also be switched between the left and right version, which practically means that its behavior is electronically adapting the direction of the flow of outdoor and indoor air. Turning the throats 90° is another and indisputable advantage during final assembly.
COMFORT+ and COMFORT regulation allows complete setting of the recuperation unit. The controller connects to the unit using a cable with RJ45 connectors (10 m in the package) - this guarantees a simple and secure connection. The control can be extended with a WIFI module and everything can be controlled conveniently using the web application. You can also connect the unit to a BMS.
The ESSENTIAL regulation is a simplified version control of the recovery unit. Still, it provides the basic and fully sufficient functions. Two potentiometers allow set the desired flow rate and time period of the night cooling (bypass). The controller is connected to the unit by 10m by cable.